You're currently on:
Replica 1938 - 1940 Knucklehead-UL FRAME
a close reproduction of the HD factory frame
Frame has forged steel parts: neck, front and rear motor mounts, side car loops, top seat yoke, footboard tabs and rear axle plates
Exact blanked and formed steel stampings are utilized in appropriate areas
Rear fender cross bar is supported by exact duplicated “saddles” brazed at each end
Seat post, brake cross shaft bushings, and grease fittings are installed
The Frame has a 28° neck angle, correct round tool box pads, and 1" diameter tank brace
Rear brake tab support slot is closed like original
Knuckle & UL Motors will fit this Frame without modifications
NOTE - THIS FRAME IS CURRENTLY ON BACK ORDER.
WE ARE TAKING ORDERS FOR NOTIFICATION!